Our customers rate For the Floor & More 4.9/5 — based on 406 reviews
Price range: £144.00 through £264.00 inc VAT
All prices include VAT
6mm toughened glass
Polished edges, made for kitchen walls.
Made for your space
Standard sizes, different dimensions and shaped glass.
Cut-outs welcome
We can plan around sockets, edges and other awkward details.
More than one panel?
We can plan the artwork so the pattern flows across them.
Rust, blue and warm cream move through repeated stars and medallions, giving Throwley a little more energy. The pattern has presence, but the repetition keeps it feeling considered rather than busy.
Send us the measurements and we’ll make the glass to suit.
We can plan around sockets, extractors and other interruptions.
A simple measured sketch is enough for us to work from.
We can arrange the artwork so the design flows across the separate pieces.
A scribbled sketch is absolutely fine.
Pick a standard size, or send us the measurements for something different.
We make sure we have the design and dimensions needed before production.
We make the glass once the design and size are confirmed.
The glass arrives with polished edges and its protective backing in place.
Choose one of the standard sizes shown on this page.
If you need a different size, a socket or cut-out, an unusual edge or more than one piece, send us your measurements or a simple sketch before ordering.
Because the glass is toughened, it cannot be cut or trimmed after manufacture.
Our splashbacks are made from 6mm toughened clear glass with polished edges and arrive ready to install.
The protective backing on the reverse forms part of the finished splashback and should not be removed.
Our 6mm toughened glass splashbacks are designed for use behind domestic gas and electric hobs and cookers.
Always follow the clearance requirements specified by the appliance manufacturer, particularly around gas burners and high-heat appliances.
Before fitting, check that the wall surface is relatively even and free of any large bumps and hollows. The wall does not have to be perfectly even: a little extra adhesive can be added in hollow areas, and less where there is a slight bump.
Lay the splashback glossy side down on a towel or blanket. Using a neutral clear low-modulus solvent-free silicone (also known as mirror adhesive), squeeze out equally sized blobs roughly 20mm in diameter and about 100mm apart. Do not put blobs too close to the edge, as the silicone may squeeze out.
Lift into position and press the glass against the wall, applying equal pressure across the panel. If any area feels uneven or bouncy when pressed, remove the glass and apply a little more adhesive to that section before lifting it into place again.
After waiting, run a bead of silicone all around the edge. With a little spray of warm soapy water, run a finger over the silicone to take away the excess and create an even seal.
Clean the glass with warm soapy water or a normal household glass cleaner and a soft cloth.
Avoid abrasive pads, scourers and harsh cleaning products, as these can mark the surface.
UK delivery for splashbacks is £9.95.
Most splashback orders arrive around two weeks after the design and size are confirmed. Splashbacks are produced to order, so please allow enough time before booking installers or other trades.
Because the glass is toughened, it cannot be cut or trimmed after manufacture, so contact us before ordering if you need a different size, a cut-out or more than one piece.
We make the glass once the design and size are confirmed.
Copyright© 2026 - For the Floor & More
Email: sayhello@forthefloorandmore.com
